Heateflex® PVDF/PFA In-Line Fluid Heaters

Benefits:

• Heated DI Water at the Point of Use
• High Reliability and Low Maintenance
• Compact Size for Ease of Installation
• No Nitrogen Purge Required

When heating massive amounts of DI water to one temperature then sending it through your facility, you do not always get the temperature range that you need for your process.  Heateflex Corporation offers a compact In-Line DI Water Heater to give you specific temperature requirements at point of use.  This allows you flexibility when you set up your process, and allows you to have better temperature control over your process.

The PVDF/PFA In-Line Heaters are 99% heating efficient, and do not require a costly nitrogen purge.  This gives you the most heat at the lowest cost providing years of savings with the long life of the heater.

back to menu

Heateflex® PVDF/PFA In-Line Fluid Heaters

Features:

• PVDF/PFA Wetted Surfaces
• Patented Heateflex® Heating Coil
• Mounting Bracket
• Units from 1 to 12 kW with World Voltages Covered

Safety Interlocks to Heater Power:

• Liquid Level Sensor
• Liquid Level Control Board
• Over-Temperature Protection
• Over-Temperature Control Board
• Process Temperature Hi-Limit

back to menu

Heateflex® PVDF/PFA In-Line Fluid Heaters

Standard Voltages: (200 – 240 VAC, 1 Phase)

Part No.	kW	Temperature Rating	Housing Length
LH2-1-01	1.0	95°C	19.5”
LH2-1-02	2.0	95°C	19.5”
LH2-1-03	3.0	95°C	19.5”
LH2-1-04	4.0	95°C	19.5”
LH2-1-05	5.0	95°C	19.5”
LH2-1-06	6.0	95°C	19.5”
LH2-1-07	7.0	95°C	19.5”
LH1-1-04	4.0	95°C	18.5”
LH1-1-05	5.0	95°C	18.5”
LH1-1-07	7.0	95°C	18.5”
LH1-1-10	10.0	95°C	27.75”
LH1-1-12	12.0	95°C	27.75”

Standard Voltages: (380 – 480 VAC, 1 Phase)

Part No.	kW	Temperature Rating	Housing Length
LH1-1-10	10.0	95°C	27.75”
LH1-1-12	12.0	95°C	27.75”

Standard Voltages: (380 – 480 VAC, 3 Phase)

Part No.	kW	Temperature Rating	Housing Length
LH1-1-10	10.0	95°C	27.75”
LH1-1-12	12.0	95°C	27.75”

Available Options:

• Recirculation Temperature Controller
• Single-Pass Temperature Controller
• Thermal Fuse Protection

back to menu

Heateflex® PVDF/PFA In-Line Fluid Heaters

* Please Note that the attached drawings are representative. The actual unit might vary from the drawing. Should you need additional information on this product line, please contact Heateflex Corporation or your local Representative / Distributor. Product manuals are also available upon request. back to menu