ElectraŽ DI Water Heating Systems
Benefits:
- Ultra-Pure PVDF/PFA Wetted Surfaces
- Compact Design for Space Savings
- Easy Installation
If space is your concern, the Electra® DI Water Heating System is for you. It allows you to place the heaters near your process, and the controls in a covenant location. The Electra® gives you flexibility when you design your system and purity when you run it. They are easy to install with wall mounting of the heater box and control box to reduce the footprint in your clean room.
back to menu
ElectraŽ DI Water Heating Systems
Features:
- Point-of-Use, One Pass, Ultra-Pure Deionized Water Heating.
- Fully Integrated Microprocessor Control and Safety System.
- Dual-Digital Readout for All Internal and Output Functions.
- Low Voltage (24 VAC), Operator Safe Control Panel.
- PVDF and PFA Wetted Surfaces on Hot Deionized Water Side - (All PFA Available).
- 10’ Umbilical Between Heater Box and Control Box.
- Flow Range of 0.5 GPM to 7.5 GPM
- Models from 15 KW to 36 KW.
- All Chemraz® O-Rings.
Safety Interlocks to Heater Power:
- Over-Temperature Safety Interlock On Each Heater.
- Power-To-Flow Control® Safety Interlock.
- Liquid Level Safety Interlock.
- Minimum Flow Safety Interlock.
- Process High Limit Safety Interlock.
- Sensor Failure/Disconnect Safety Interlock.
- Emergency-Off Button Safety Interlock.
back to menu
ElectraŽ DI Water Heating Systems
Standard Voltages: (200 – 480 VAC, 3 Phase)
Model No. |
kW |
Heater Box Dimensions (HxWxD) |
Controller Box Dimensions (HxWxD) |
KDI915 |
15 |
26” x 28” x 7” |
27” x 20” x 12” |
KDI921 |
21 |
26” x 28” x 7” |
27” x 20” x 12” |
KDI927 |
27 |
36” x 28” x 7” |
27” x 20” x 12” |
KDI930 |
30 |
36” x 28” x 7” |
27” x 20” x 12” |
KDI936 |
36 |
36” x 28” x 7” |
27” x 20” x 12” |
Available Options:
- Resistivity Sensor
- Ground Fault Circuit Interrupt
- 50’ Umbilical Between Heater Box and Control Box
back to menu
ElectraŽ DI Water Heating Systems
Downloads:
* Please Note that the attached drawings are representative. The actual unit might vary from the drawing. Should you need additional information on this product line, please contact Heateflex Corporation or your local Representative / Distributor. Product manuals are also available upon request.
back to menu
